PS100 - Low VOC - 90% Solids Polyaspartic Sealer

PS100 is a high-performance, two-component, 90% solids polyaspartic sealer known for its durability, chemical resistance, UV stability, and abrasion resistance. It can serve as both a base coat and topcoat over decorative broadcast systems like paint chips and colored sand, offering extensive customization options. With low VOC content (less than 100 grams per liter), PS100 is an eco-friendly choice that meets most air quality regulations, making it suitable for government buildings, healthcare facilities, schools, retail spaces, and other settings where indoor air quality is a priority. It also provides a longer working time for ease of application and a quick tack-free time, reducing installation downtime. 

RECOMMENDED FOR: Ideal for medium build broadcasted floors with limited installation time. Suitable over broadcasted or troweled systems, providing a thin to medium build sealer that enhances durability and aesthetics. Perfect for commercial, industrial, and residential use in settings like government buildings, hospitals, schools, auto service centers, garages, and warehouses where quick turnaround and high quality are essential.

CURE SCHEDULE:  (70°F) (70% relative humidity)

Pot Life – (150 grams mass) …………….......…...…...….. Greater than 2 hours

Actual usable working time is approximately 20-25 minutes, depending on environmental conditions and volumes

Tack Free (dry to touch)………………...…...………………… 3 to 7 hours

Recoat or Topcoat .....…………….……..…................................. 5 to 8 hours

Light Foot Traffic ...………………………..………................…12 to 24 hours

Full Cure (heavy traffic) ...…………….....…………..….......24-72 hours 

SOLIDS BY WEIGHT: 91% (+/- 2%)
SOLIDS BY VOLUME: 89% (+/- 2%)
VOLATILE ORGANIC CONTENT: Less than 100 grams per liter
COLORS: Clear - Gardner Color 1 - 2
RECOMMENDED FILM THICKNESS: 5-12 mils wet (When applying directly to concrete, ensure the substrate is properly prepared, and moisture content is tested. Avoid application on damp surfaces.)
COVERAGE PER GALLON: 133 - 320 FT2 per gallon
PACKAGING INFORMATION:
2.5 gallon kit (other special kit sizes available upon request (packaging info is approximate net volume) MIX RATIO: 12.9 pounds of Part A to 9.2 pounds of Part B, or approximately 1.5 gallons of Part A to 1 gallon of Part B.
SHELF LIFE: 6 Months in unopened containers
FINISH CHARACTERISTICS: Gloss (>70 at 60 @ glossmeter)
COMPRESSIVE STRENGTH: 11,600 psi @ ASTM D695
TENSILE STRENGTH: 3,900 psi @ ASTM D638
ULTIMATE ELONGATION: 2.9%
HARDNESS: Shore D= 30 - 40 (typical)
ABRASION RESISTANCE:
Taber abraser CS-17 calibrase wheel with 1000 gram
total load and 500 cycles= 20 mg loss
ADHESION: 340 psi @ elcometer (concrete failure, no delamination, applied to shot blasted concrete.)
VISCOSITY: Mixed = 1000 cps (typical)

DOT CLASSIFICATIONS:
Part A: “UN1993, FLAMMABLE LIQUID N.O.S. (CONTAINS Xylene. Ethylbenzene), 3, PG III
Part B: “UN1993, FLAMMABLE LIQUID N.O.S. (CONTAINS Xylene, Ethylbenzene), 3, PG III for further solutions / options.