GC100 Epoxy Mortar Grout Coat

COVERAGE PER GALLON: 267 square feet per gallon @ 6 mils per coat (coverage may vary depending on actual mortar porosity) or 100-133 square feet per gallon for one coat applications @ 12-16 mils. 

CURE SCHEDULE (70 Degrees F)

Pot Life (1 1/2 Gallon): 20 to 30 Minutes
Tack Free (Dry to Touch): 5 to 8 Hours
Recoat or Topcoat: 9 to 14 Hours
Light Foot Traffic: 14 to 18 Hours
Full Cure (Heavy Traffic): 2 to 7 Days
Application Temperature: 50-90 degrees F with relative humidity below 90%

SOLIDS BY WEIGHT: 100% (+/- 1%)
SOLIDS BY VOLUME: 100% (+/-1%)
VOLATILE ORGANIC CONTENT: Zero pounds per gallon
STANDARD COLORS:White, off white, light gray, medium gray, tile red, beige, and clear (clear is opaque clear)
OTHER COLORS ALSO AVAILABLE:Dark gray, charcoal gray, brown, tan, and light blue
RECOMMENDED FILM THICKNESS:6 mils (2 coats recommended) or 12-16 mils (1 coat)
COVERAGE PER GALLON: 267 square feet per gallon @ 6 mils per coat (coverage may vary depending on actual mortar porosity) or 100-133 square feet per gallon for one coat applications @ 12-16 mils.
PACKAGING INFORMATION: 3 gallon kit (25.3-25.7 pounds net approximately)
MIX RATIO:(1 gallon) part A to (.50 gallons) part B (volumes approx.) 8.7-8.9# part A per 3.95# part B for colors and 9.3# part A to 4.6# part B for the clear.
SHELF LIFE: 1 year in unopened containers
FINISH CHARACTERISTICS: Gloss (>60 at 60 degrees @ glossmeter)
ABRASION RESISTANCE: Taber adrasor CS-17 calibrase wheel with 1000 gram total load and 500 cycles = 34 mg loss ADHESION: 400 psi @ elcometer (concrete failure, no delamination)
VISCOSITY: Mixed= 3000-4000 cps (typical)
DOT CLASSIFICATIONS:
Part A “not regulated”
Part B “CORROSIVE LIQUID N.O.S., 8, UN1760,PGIII”
FLEXURAL STRENGTH: 8,400 psi @ ASTM D790
COMPRESSIVE STRENGTH: 10,700 psi @ ASTM D695
TENSILE STRENGTH: 6,900 psi @ ASTM D638
GARDNER VARIABLE IMPACTOR: 50 inch pounds direct – passed
HARDNESS: Shore D = 87
ULTIMATE ELONGATION: 2.9%
PRIMER: Recommend epoxy mortar power trowel overlay system as a starting base
TOPCOAT: Optional: A variety of epoxy and urethane topcoats are compatible